Home/Case Studies/Film scrap to reusable pellets
Project configuration
Film scrap to reusable pellets
Granulating lines that turn film scrap and edge trim back into pellets for the same production hall — cutting material cost and waste, with pellets ready to feed the blown film line again.
Project configuration
Project configuration
Typical configuration from our project base. Exact values are confirmed in the proposal for your line.
| Parameter | Details |
|---|---|
| Screw diameter | Ø100 – 150 mm |
| Output | 150 – 500 kg/h |
| Main motor | 30 – 90 kW |
| Screw L/D | 28:1 – 32:1 |
| Materials | HDPE / LDPE / PP |
What the line includes
How a project is delivered
From specification
to running line
A machinery project is a process, not a shipment. Four steps keep every installation on schedule.
Engineered to your spec
Material, film width, output rate and factory conditions define the line. Every component is confirmed in the proposal before production starts.
Built & factory tested
Machines are assembled and run with your recipe before shipment. Videos and test reports are shared so you see the line running before it leaves.
Installed & commissioned
Engineers supervise installation on site, run the first production trials and hand over a documented, tuned line.
Supported for life
24/7 technical support, structured operator training and OEM spare parts shipped globally — from first run to full production.
Buyers ask
Before you start
a project
Can you share customer references?
Yes, on request. The typical configurations above show what we build; for your market we can arrange direct references, a factory visit or a video walk-through before you order.
Do you provide installation and commissioning?
Yes. Our engineers supervise installation on site, run the first production trials and hand over a documented, tuned line, worldwide.
How fast is your technical support?
24/7 support line to our engineering team in more than 50 countries, average first response within 4 hours on business days.
How quickly can I get spare parts?
Original spare parts - screw elements, die rings, sealing bars, drives and control boards - are shipped globally; urgent parts are dispatched within 48 hours.
Can you upgrade my existing line?
Yes. Line modernization adds co-extrusion heads, servo drives or process controls to raise output and cut waste without replacing the whole line.
Get your custom solution
Your project,
engineered next
Tell our engineering team your output target and facility conditions. We design and build machinery to match — average response time 4 hours.
Start Your Project →